Skip to main content

SolarEdge

Enabling Modbus TCP

  1. Ensure the inverter is connected to your network either via Ethernet or Wifi
  2. Locate the on/off switch on the inverter (usually has a red cap, near the bottom left of the inverter)
  3. Push the switch to the left (P) for 1 second, then release
  4. Scan the QR code on the right side of the inverter with your phone camera and connect to the WiFi network indicated by the code
    • Note: You may get a notification that the network not having internet access. If this happens, select "Use network anyways"
  5. Open a web browser and navigate to http://172.16.0.1/
  6. Under "Communication Settings" enable the Modbus TCP option and make note of the port shown (usually 502 or 1502)